Expert Answers about Boat Tables

• What Boat Table Does Replacement Table Leg # 315-DTX Fit
• The part # 315-DTX is a replacement part for the Rectangular Boat Table # 315-DSH-KF which is designed to fit a 3 inch hole and comes with a table top. We don't have a way to use the # 315-DTX without the base.
  view full answer...


• Can JIF Marine Rectangular Boat Table Be Taken Apart Easily
• The JIF Marine Rectangular Boat Table # 315-DSH-KS that you referenced is going to work perfectly for your application. The black mounting base, once bolted to the floor, is the only component that will be permanently installed when setting up the table. The vertical support tube simply pops into the base and then pops into the circular cutout on the bottom of the table. When it's time to break down the table you will simply pull up on the tube to remove it from the base (and then pull...
  view full answer...


• What Replacement Tires do I Need for My A78-13 Boat Trailer Tires?
• The new equivalent of tire size A78-13 is 175/80-13. This is the exact same size, so there should not be any interference at all with your fenders that fit the A78-13. I went ahead and attached a FAQ article and table that shows this translation. As far as using passenger car tires, we strongly do not recommend this for a couple reasons. Firstly trailer tires have stiffer sidewalls and do a better job dealing with vertical loads when hauling. Also, since trailers do not have turning axles,...
  view full answer...


• Long Cable Winch Solution for Moving WaveRunner and Beach Cart 75 Feet
• I really wish we had an electric winch with a long enough cable, but all of the AC powered winches we offer have a max cable length of 25 feet. 75 feet is quite a bit for any electric winch though so I am not sure what would be best solution.
  view full answer...


• Recommended Slipper Spring and Hanger to Make Trailer Functional
• We unfortunately do not have exactly the spring you are looking for. What I recommend is getting the 3-Leaf Slipper Spring w/ Radius End for 1,500-lb Trailer Axles - 24-5/8" Long # SP-178275 and moving your rear hanger forward because you will be within 1/4 inch of where your axle would have been with this spring. Then you will be able to replace springs as needed and still support your sailboat properly for transport. If you want a bolt on slipper spring hanger for the rear, I recommend...
  view full answer...